RISCO Group LightSYS - Manual (Page 48)

LightSYS User Manual Page 48
Appendix D – SMS Operation
The LightSYS enables you to perform remote control operations using simple SMS
commands. The following section describes the SMS commands and the response of the
system to these commands.
Note: This application is available only if a GSM/GPRS module is installed in your system.
Operation SMS Message Structure Example
Full Away Arm [Code] A 1234A
Home Arm [Code] H 1234H
Group Arm [Code][G][Select a one Group
A/B/C/D]) 1234GA
Full disarm [Code] D 1234D
Arm by partition [Code] A [Partition No.] 1234A1
Home Partition
Arm [Code] H [Partition No.] 1234H1
Group Arm by
Partition [Code] G [Select one Group A/B/C/D]
[Select partitions]
Disarm by Partition [Code] D [Partition No.] 1234D1
Bypass a zone [Code] B [zone number] 1234B05
Un-bypass a zone [Code] UB [zone No.] 1234UB05
Activate Output [Code] UOON [UO No.] 1234UOON1
Deactivate Output [Code] UOOFF [UO No.] 1234UOOFF1
Change FM
number [Code] FMPHONE [FM serial number]
NEW [New Phone No.) 1234FMPHONE 3
NEW0529692345
Get system status [Code] ST 1234ST
Get last alarm [Code] AL 1234AL
Get SIM credit level
(for prepaid cards) [Code] CR 1234CR
Notes: SMS commands are not case sensitive (they can contain both capital, small or mixed letters).
A separator between command words is not required, although it is accepted.
SMS Confirmation Message
A confirmation message following a SMS operation is sent to the user, upon request, by
adding the letters “RP” at the end of the SMS messages listed below.
Example:
1234 A RP - A confirmation message following an arming operation is sent to the user.
Confirmation or Fail operation messages can be assigned to the actions of arming,
disarming, bypassing, activating outputs or changing follow me definitions.