RISCO Group LightSYS - Manual (Page 20)

Arming and Disarming
LightSYS User Manual Page 20
Important:
If the alarm was caused by a tripped smoke detector(s), the keypad's Fire ( )
indicator will remain lit, providing an indication that the fire system must be
reset before it will be capable of detecting subsequent infractions. Furthermore,
until it is reset, you will be prevented from setting your system.
To reset a smoke detector, press > User Code >
> Activities
> > Advanced > > Switch Auxiliary >
.
Note: You may need to perform this procedure several times in order to prevent
the smoke detector(s) from re-detecting any remaining smoke
Press to exit the user functions mode.
Resetting after an alarm
Your installation company can configure the reset of the system to a normal operation
mode to require the intervention of your monitoring station or installer. In this case, after
an alarm condition, the system will be regarded as not ready and the display will show a
Call Installer message.
Consult your installer regarding whether your system reset mode is Remote or Installer.
Note:
Before attempting to reset your system ensure that the system is disarmed.
To remotely (anti-code) reset after an alarm
1. Press key while the Call Installer display is on will enter you to the Anti
Code section.
2. Press to enter the Anti Code option.
3. Call your monitoring station (MS) or installer and quote the RANDOM CODE displayed on
your keypad. The MS or installer will give you a return Anti-Code.
4. Enter this Anti code followed by to reset the system.