RISCO Group LightSYS - Manual (Page 36)

User Functions and Settings
LightSYS User Manual Page 36
6. When you have finished entering the series of characters, ensure that the cursor is
placed in the field after the last character in the series, and press A (or the function
key you selected in step 4) again. The series of characters is saved and assigned to the
selected function key
Activating a Macro
Press / /
/
on the keypad for two seconds to activate the macro A/B/C/D
respectively.
Parking Control with LightSYS Gate Control Keyfobs
If your system is equipped with wireless receiver it can support up to 200 keyfobs that can
be used for controlling two outputs for gate and parking control. These keyfobs are
additional to the keyfobs that can be used to control the security applications of the
system. Each keyfob had a dedicated button to support each output.
The Grand master or the installer can control the management of these keyfobs
Notes:
The following procedures are relevant only for stand-alone keyfobs. The keyfobs that
control the security system can be defined and programmed only by your installer.
Your installer must define the outputs and the way they will operate so you can perform
the following procedures.
Assign New Keyfob
1. Press and enter Grand Master code followed by .
2. Using the arrow keys, scroll to the option Stand Alone KF and press .
3. Select the receiver that you want to assign the keyfob to and press .
4. Using the arrow keys, scroll to the New Keyfob option and press .
5. Press the key to start the keyfob registration mode.
6. Press the keyfob key for 3 seconds.
7. Repeat step 6 for additional keyfobs. When finished press to exit registration
mode.
Delete a keyfob
1. Follow steps 1-3 of the previous procedure (See Assign New Keyfob)
2. Using the arrow keys, scroll to the Delete Keyfob option and press .
3. Press the key to start the keyfob erase mode.