RISCO Group LightSYS User Manual
Page 39

User Functions and Settings
Page 39
LightSYS User Manual
Operation
GM
U
In.
Keypad Sound
√
√
√
Chime
Keypad Chime—Allows to control (turning ON and OFF) of
the current keypad's internal sounder for any function
involving the Chime feature.
Partition Chime— Allows to control (turning ON and OFF)
of all keypad buzzers in the partition for any function
involving the Chime feature.
Buzzer On/Off: Used to control (Turning ON and OFF) the current
keypad's internal buzzer during both Entry and Exit
Delay time periods and all fire and burglar alarms.
Anti Code
√
√
-
Some systems (defined at the time of their installation) are not
ready to be reset after an alarm or tamper condition. To restore the
system to normal operation mode, an installer code or anti-code
must be entered. Entering the code supplied by the technician at
this location will restore the system to the normal operation mode.
Configure SW
√
-
-
Enable CS: Each time this function is enabled, your alarm
company may subsequently gain a single remote access to your
system to make any required programming changes.
CS connect (Initiate Call): Enables to establish communication
between your system and your alarm company to allow them to
perform a remote programming operation on your system using
the remote configuration software. Select the communication
method (IP or GPRS) as guided by your installer.
Prepaid SIM
√
-
-
Check Credit: Use this function to receive information by SMS or
voice of the credit level in your prepaid SIM card. For more
information consult your installer.
Reset SIM: After charging a prepaid SIM card, the user has to
reset the SIM expire time manually. The time period duration for
expiration is defined by your installer.