RISCO Group LightSYS - Manual (Page 21)

Arming and Disarming
Page 21 LightSYS User Manual
To locally (from the keypad) or remotely reset your system (by your MS or installer)
1. Press
Code Activities Config SW CS Connect
Via GPRS/IP? [if both GPRS and IP are available, you must select which]. Press
to confirm
2. Done is displayed. A one hour time window is opened for the installer to program user
functions and be able to reset your system.
Duress Disarming
If you are ever coerced into disarming your system, you can comply with the intruder's
wishes while sending a silent duress alarm to the monitoring station. To do so, you must
use a special duress code, which when used, disarms the system in the regular manner,
while simultaneously transmitting the duress alarm. Confirm with your installer which of
the user codes is defined as a duress code
:
Note:
Under no circumstances must the duress code be used haphazardly or
without reason. Central stations, along with police departments, treat
duress codes very seriously and take immediate action.
Disabling a Fire Alarm (Switch Auxiliary)
Unsetting the fire alarm interrupts the power supplied to the system's smoke detector(s)
for a predetermined interval, thus resetting and "readying" them for subsequent alarms.
Note:
You may need to perform this procedure several times in order to
prevent the smoke detector(s) from re-detecting any remaining smoke.
To disable a fire alarm
1. Press and enter your grand master code followed by .
2. Using the arrow keys, scroll to the option Activities and press .
3. Scroll to Advanced and press .
4. Scroll to Switch AUX and press .
5. The fire alarm is disabled for a predefined amount of time.