Enterasys Networks 2000 - Manual (Page 62)

The SmartSwitch 2000 Chassis View
2-42 Managing the Hub
You can also view information concerning the UPS connected to your
SmartSwitch 2000 including:
• The amount of time that your UPS has been running since the last start-up
• The line voltage and battery output
• The actual battery capacity of the UPS (dynamic bar graph)
You can also use a button at the bottom of the window to disconnect your UPS, or
you can use the Test option to initiate a self test of the unit.
To access the UPS window:
1. From the Chassis View window, click on Device in the menu bar to access the
Device menu.
2. Select UPS. The UPS window, Figure 2-16 , opens.
Figure 2-16. The UPS Window
UPS ID
Displays the manufacturer and model typecode of the UPS attached to the COM
port of the SmartSwitch 2000. You must assign this typecode for the UPS window
to be active. (See
Setting the UPS ID , on page 2-43 , for instructions for setting the
typecode for your UPS.) The valid typecodes are:
• Model 370
• Model 400
• Model 600
• Model 900