N in, Figure 2-1 – Enterasys Networks 2000 User Manual
Page 55
Managing the Hub
2-35
The SmartSwitch 2000 Chassis View
Figure 2-14. The Ethernet Configuration Window
From this window you can manually set the operational mode of the port, or —
for 100Base-TX and 1000Base-SX/LX/CX interfaces — set the port to Auto
Negotiate so that the appropriate operational mode can be determined
automatically. The mode you set will determine the port’s speed, duplex mode,
and flow control.
The window displays the following information about the selected Ethernet port:
Port Type
Displays the port’s type: 100Base-TX RJ-45or RJ71 (for built-in Fast Ethernet ports
and the FE-100TX Fast Ethernet port module), 100Base-FX MMF SC Connector
TIP
If you select the Configuration option available for a standard Ethernet or FDDI interface
or for a Fast Ethernet port on a first generation device, an entirely different window opens;
see
Configuring Standard Ethernet and FDDI Ports
Ethernet Ports on First Generation Devices
, for information on
configuring these ports.