Enterasys Networks 2000 - Manual (Page 27)

Viewing Chassis Information 2-7
The SmartSwitch 2000 Chassis View
• I/F Speed will display the port’s bandwidth: 10M (megabits) for Ethernet;
100M for Fast Ethernet; 155.5M for ATM; and 1G for Gigabit Ethernet.
• I/F Type will display the port type of each port on your SmartSwitch 2000, e.g.,
Eth (ethernet-csmacd), ATM, or FDDI.
• VLAN Mapping displays if your device has been configured to operate in
802.1Q mode. It displays the VLAN ID number associated with each port on
your SmartSwitch 2000.
For Ethernet MicroLAN Switches, the Port Status menu contains the following
options:
• Load will display the portion of network load processed by each port as a
percentage of the theoretical maximum load of the connected network
segment (10, 100, 155.5, or 1000 Mbps).
• Port Assignment will display each port’s repeater channel assignment (A-H).
• Status allows you to select one of three status type displays: Admin/Link,
Admin, or Link.
• Errors , and Frame Size allow you to display the percentage per port of the
specific Error or Frame Size you select.
For more information on the port display options available via this menu, see Port
Status Displays , on page 2-10 .
The Repeater Menu
If you are modeling an Ethernet MicroLAN Switch, the Repeater menu displays,
offering the following options for each repeater segment (A-H) on the device:
• Statistics
• Timer Statistics
• Performance Graph
• Alarm Limits
• Trap Selection
Refer to Chapter 5, Managing Ethernet MicroLAN Switches , for information on
these menu selections.
The FDDI Menu
If your SmartSwitch 2000 has an installed HSIM-F6, the FDDI menu displays on
the Chassis View menu bar, with the following options:
• Configuration
• Connection Policy
• Station List
• Performance
• Frame Translation
Refer to Chapter 6, FDDI Applications , for information on these menu selections.