Epson ACULASER C3800 - Manual (Page 68)

Using the Printer Software with Windows 68
EPSON AcuLaser C3800 User's Guide
Using storage form overlay
This function enables faster printing with form overlay data. Windows users can use the
form data registered on the USB memory installed in the printer’s USB Host interface or
delete the form data on the USB memory. You can access this function from the Form
Selection dialog box in the printer driver.
Note:
❏ This function is not available if the USB memory is not installed on the USB Host interface of
the printer.
❏ When the document’s resolution, paper size or paper orientation settings are different from the
form overlay data that you use, you cannot print the document with the form overlay data.
❏ This function is available only in ESC/Page mode.
❏ This function is available in the High Quality (Printer) mode.
❏ We recommend using a USB memory that has less than 2 GB of memory. Accessing USB
memories that have more than 2 GB of memory may take too long.
❏ If a large numbers of files are in the USB memory, accessing the USB memory may take too
long.
❏ If accessing the USB memory takes too long, try formatting it to improve the access speed.
Register the form overlay data on the USB memory
Only a network administrator using Windows XP, XP x64, 2000, Server 2003, or Server
2003 x64 is allowed to register the form overlay data on the USB memory, using the
following steps.
Note:
The form name must use only the characters shown below. A - Z, a - z, 0 - 9, and ! ’ ) ( - _ %
1. Prepare the form overlay data to register on the local PC Hard Disk Drive.
2. Log in to Windows XP, XP x64, 2000, Server 2003, or Server 2003 x64 as an
administrator.
3. For Windows 2000, click Start, point to Settings, and then click Printers.
For Windows XP, XP x64, Server 2003, or Server 2003 x64 click Start, point to Control
Panel, and then double-click the Printers and Faxes icon.
4. Right-click the EPSON xxx xxx icon and then click Properties.
5. Click the Optional Settings tab.
6. Click Register. The Register to Storage dialog box appears.