Epson ACULASER C3800 - Manual (Page 199)

Using the Control Panel 199
EPSON AcuLaser C3800 User's Guide
Paper Out tttt sssss
There is no paper in the specified paper source (tttt). Load paper of the size (sssss) into
the paper source.
Paper Set tttt sssss
The paper loaded in the specified paper source (tttt) does not match the required paper
size (sssss). Replace the loaded paper with the correct size paper and press the
N
Start/Stop button to resume printing, or press the + Cancel Job button to cancel the
print job.
If you press the N Start/Stop button without replacing the paper, the printer will print on the
loaded paper even though it does not match the required size.
Please Select File
Print Start is selected without selecting the file. Select the file and try again. See
"Document Print Menu" on page 169 or "Image Print Menu" on page 171 for details.
Please wait for print
Printing cannot start because the previous job is being processed. Try again after a few
seconds.
Printer Open
The front cover is open. To clear this error, close the front cover.
Print Overrun
The required time to process the print data exceeded the print engine speed because the
current page is too complex. Press the N Start/Stop button to resume printing, or press the
+
Cancel Job button to cancel the print job. If this message appears again, select On as
the Page Protect setting in the control panel’s Setup Menu or select Avoid Page Error on
the printer driver.
If you continue to receive this message when printing a particular page, try simplifying the
page by limiting the number of graphics or reducing the number and size of fonts.
To avoid this error, it is recommended that you set the Page Protect setting to On and add
more memory to the printer. See "Setup Menu" on page 175 and "Memory Module" on
page 220 for details.
RAM CHECK
The printer is checking the RAM.