Epson ACULASER C3800 - Manual (Page 163)

Using the PCL6/PCL5 Printer Driver 163
EPSON AcuLaser C3800 User's Guide
Chapter 7
Using the PCL6/PCL5 Printer Driver
About the PCL Mode
Hardware requirements
Your printer must meet the following hardware requirements to be able to use the
PCL6/PCL5 printer driver.
Memory requirements for using the PCL6/PCL5 printer driver are shown below. Install
optional memory modules into your printer if the amount of memory currently installed does
not meet your printing needs.
* Printing may not be possible with this amount of memory, depending on the specifics of the job being
printed.
System requirements
Your computer must meet the following system requirements to be able to use the
PCL6/PCL5 printer driver.
To use the PCL6/PCL5 printer driver, your computer must be running Microsoft Windows
XP or have installed the 2000 Service Pack 3 or later.
For Windows XP or 2000
Minimum memory Recommended memory
128 MB* (for a simple print job at 600 dpi) 256 MB* or more
Minimum Recommended
Computer IBM PC series or IBM compatible with
Pentium or higher CPU IBM PC series or IBM compatible with
Pentium II or higher CPU
Hard Disk 10-25 MB free (for driver installation)
Memory 128 MB (256 MB for Server 2003) 256 MB
Display Super VGA supporting 640
× 480
Super VGA supporting 800
× 600 or
more