KACO blueplanet gridsave eco 5.0 TR1 - Manual (Page 28)

Configuration and Operation
Page 28 Operating instructions for blueplanet-gridsave eco_EN
Authorised electrician
8 Configuration and Operation
8.1 Controls
The device has a status LED with control buttons.
10 7 8
9
2 3 4
5
6
A
C
B
1
Figure 13: Overview (control elements)
A On button
↻ Status LED (Pos. 5) OFF.
" Switch on the device by pressing the button ( >1 second).
» Status LED (Pos. 4) comes on.
" Press again (>1 second) to put the device into no-load mode.
" Activate eco mode by tapping the button (<1 second).
B Generator start/stop button
↻ Device in operation.
" Switch the generator on or off by pressing the button (<1 second).
» Status LED (Pos. 1) is on.
B Activate regenerative charging
↻ Device in operation.
" Carry out regenerative charging of the battery with two long presses of the button (>2 seconds).
» Status LED (Pos. 8) flashes.
C Switch alarm tone on/off
↻ Alarm is sounded
" Mute alarm tone by pressing the button.
» Alarm is still on without an audio signal. Note the fault!