KACO XP83U-H6 (Canada) - Manual (Page 26)

Page 26
7. ELECTRICAL CONNECTION
The electrical connections should only be made after the inverter has been installed in its final location. To
complete the electrical connections, the AC and DC terminal connections must not be connected to any
source of voltage. This will protect the installer from harm and ensure that the inverter is not accidentally
activated.
CAUTION!
After the inverter has been installed in the fixed location, the electrical connection can be established
Please be sure that both AC and DC side are disconnected from all voltage sources.
Please be sure that the switches are locked out and switching-on unintentionally is not possible.
NOTICE!
The electronic printed circuit board components in the inverter can be damaged by static electricity.
When handling the printed circuit boards, please follow ESD safety regulations.
To prevent the damage from static electricity, touch the enclosure of the grounded inverter.
Please go to the next step when you are sure it is safe.