KACO XP83U-H6 (Canada) - Manual (Page 11)

Page 11
Regulations concerning the prevention of accidents
During the operation of the inverter, certain parts of the device carry high voltages, which may lead to severe
personal injury or even death. The following precautions should be followed to minimize the risk of lethal
hazards or personal injuries.
The installation of the device must be in compliance with the relevant safety regulations or other applicable
national or local provisions. Proper ground, conductor dimensioning and an appropriate short-circuit
protection must be provided to ensure operational safety.
All instrument covers must remain closed during operation.
Prior to performing some visual checks and maintenance work the inverter must be disconnected from all
power sources and protected against inadvertent activation. If measurements have to be conducted while
the inverter is connected to power, NEVER touch live terminals. Remove all jewelry from your wrists and
fingers. Ensure that the test equipment is in a proper and safe operating condition.
When working on the inverter while energized, make sure to stand on an insulated surface and ensure that
there is no connection to ground.
Follow the instructions exactly as given in these operating and installation instructions and especially
observe all information concerning possible hazards, warnings and precautions.
This manual may not cover all possible scenarios. Should a specific problem occur that is not sufficiently
explained, please contact your dealer or KACO new energy.
Modifications/Changes
CAUTION!
Hazard of damage due to unauthorized modifications/manipulation! By no means manipulate the inverter or
modify or change the inverter or any other parts of the installation
Performing any modifications or changes on the inverter is generally prohibited. Performing any changes or
modifications to the installation of the inverter is only permitted if in compliance with national standards and
performed by qualified personnel.