KACO XP83U-H6 (Canada) - Manual (Page 23)

Page 23
6. CONNECTING THE CONDUIT
In this section, see how to insert the cables in the inverter and where to punch the holes for the
conduit fittings.
NOTICE!
When installing, please be cautious that water is not able to enter into the inside of the cabinet.
Only recognized NEC compliant watertight conduit and fittings must be used for outdoor
applications. Moisture can affect the performance of the inverter through improper conduit or
hubs.
How to install the cables
There are two ways of connecting cables shown in the following figures.
The field wiring area is designed for DC cable, AC cable and data cables.
The conduit entry points can be used for any cables. Example: Left side for DC conduit and bottom for AC
conduit.
Using the left side panel for cables
1. Remove the bolts which secure the plate to the inverter.
2. Remove the plate.
3. Mark all the holes for the conduit. You need conduit for the AC, DC and data cables.
4. Punch holes for the conduit.
5. Attach the plate to the Inverter.
6. Attach the bolts and tighten.
7. Attach the conduit with the appropriate conduit fittings.
a. Ensure that proper conduit duct sealant is used to prevent rodent and insect infestation.
b. The bottom plate must be secured in place during operation. If conduit is used, the
proper conduit fittings must be used.