Yaskawa DeviceNet Option Card CM05x - Manual (Page 33)

DeviceNet EDS Files 5-4
The EDS files provided with the Drive DeviceNet Option Board allow the DeviceNet configuration tool to access
various groups of parameters within the Drive. The following parameter groups are defined in the Drive
DeviceNet EDS files:
• DN: Motor Data
• DN: Control Data
• DN: AC Drive Data
• DN: Polled Config
• A Parameters
• B Parameters
• C Parameters
• D Parameters
• E Parameters
• F Parameters
• H Parameters
• L Parameters
• N Parameters
• O Parameters
• T Parameters
• U1 Parameters
• U2 Parameters
• U3 Parameters
• Status
• ACCEPT/ENTER
• Serial Number
The DN: Motor Data parameter group is used to configure the Drive for the motor that will be used with it. The
parameters in this group include motor type, motor rated current, motor rated voltage, motor rated frequency,
motor maximum speed, and motor base speed. These parameters must be set to the values shown on the
motor nameplate. A list of DN: Motor Data can be found in Appendix A. See Chapter 6 for more information on
how to configure this data.
The DN: Control Data parameter group provides control information (running forward, running reverse, Drive fault,
network run/stop enable) from the Drive. A list of DN: Control Data can be found in Appendix A.
The DN: AC Drive Data parameter group provides Drive configuration and status parameters related to Drive
mode, actual speed, actual current, current limit, input voltage, acceleration time, deceleration time, and network
frequency enable. A list of DN: AC Drive Data can be found in Appendix A.
The DN: Polled Config parameter group is used to configure the DeviceNet Polled Connection. The parameters
in this group determine the content of the information that is passed to and from the Drive during polled operation.
The information that is passed to the Drive from the Master device is setup with the Polled Consuming Assembly
parameter. The information that is passed from the Drive to the Master device is setup with the Polled Producing
Assembly parameter. A list of DeviceNet Polled Config data can be found in Appendix A. More information on
setting up the DeviceNet Polled Connection can be found in Chapter 6.