SMA SB 2500TL-21 Installation - Manual (Page 45)

SMA Solar Technology AG Electrical Connection
Installation Manual SB25-30TLST-21-IA-en-13 45
6.5.1 Checking the Country Standard
Make sure that the inverter is set to the country of installation.
Before commissioning:
• Check that the country standard of the inverter is correct by comparing the default settings of
the inverter listed on the supplementary sheet provided.
After commissioning:
• Check that the country standard is correct on the basis of the display message during
(re-)commissioning (see Section 7 "Commissioning" (page 52)).
• Check whether the country standard is correct by tapping the display twice and viewing the
display messages of the start-up phase again.
or
• Check that the country standard is correct using the "SMA grid guard" measuring channel via
a communication product.
The settings of each country data set are specified in the operating parameters. The parameters can
be read using a communication product. The description of the operating parameters is available at
www.SMA.de/en in the category "Technical Description" of the respective inverter.
Display language
Once you have set the country standard, you can always set the display language later
using rotary switch B. However, you have to then set rotary switch A to "0" in order to keep
the country data set.
(A) (B) Country data set Display language Grid Guard
protection Country
0 0 default setting default setting dependent on
parameter set dependent on
parameter set
0 1 retained English dependent on
parameter set dependent on
parameter set
0 2 retained German dependent on
parameter set dependent on
parameter set
0 3 retained French dependent on
parameter set dependent on
parameter set
0 4 retained Spanish dependent on
parameter set dependent on
parameter set
0 5 retained Italian dependent on
parameter set dependent on
parameter set
0 6 retained Greek dependent on
parameter set dependent on
parameter set
0 7 retained Czech dependent on
parameter set dependent on
parameter set