SMA POWER PLANT CONTROLLER - Manual (Page 39)

SMA Solar Technology AG 7 Operation
Operating Manual PPC-BE-P7-en-13 39
7.12 Calling Up the System Overview
7.12.1 Calling Up the Overview of the Entire System
In the overview "My system" you will find an overview of the current data of the entire PV system and the status of the
measured values.
To facilitate identification of your system, you can enter the name of your system on this page. This name will then appear
instead of "My system" in the first-level navigation line.
Procedure:
1. Log into the user interface (see Section 11.3.1, page 54).
☑ The overview "My system" now opens.
2. If required, enter the name of the system in the field System name.
3. If required, adjust the power of the PV system in the field System power (in installer mode).
7.12.2 Retrieving the Status and Current Data of All Devices in the System
1. Log into the user interface (see Section 11.3.1, page 54).
2. To call up an overview of the number of devices in the PV system and the status of these devices, select PPC >
Overview.
3. To call up the data of the connected sensors, go to PPC > Measurement values > Measurements common.
4. To call up the status and the current data of the connected inverters, go to PPC > Spot values > System
communication > Inverter.
5. To call up the status and the current data of the connected Cluster Controllers, go to PPC > Spot values > System
communication > Cluster Controller.
6. To call up the current data of the network analyzers, go to PPC > Spot values > System communication > Power
Analyzer.