HEIDENHAIN iTNC 530 (340 420) - Manual (Page 8)

IV
Changed features of the NC software 340 420-xx
n Cycle 32 Tolerance was expanded so that different filter settings
can be selected for High Speed Cutting (HSC) (see “TOLERANCE
(Cycle 32)” on page 359).
n In Cycle 210 (Slot with reciprocating plunge), the approach behavior
for finishing was changed (see “SLOT (oblong hole) with
reciprocating plunge-cut (Cycle 210)” on page 281).
n The additional status display was expanded to display the active
status of program section repeats and subprogram calls.(see
“Program section repeats/subprograms” on page 12)
n When contents of Q parameters are checked, 16 parameters are
now shown in a separate window.(see “Checking and Changing Q
Parameters” on page 386)
n The number of contour elements permitted in SL Cycles, Group II,
has been increased from approx. 256 to approx. 1024 (see “SL
Cycles” on page 294).
n The transfer of the current tool position coordinates into the
program has been improved (see “Actual position capture” on page
66).
n The transfer of the value that is calculated by using the on-screen
pocket calculator into the program has been modified (see
“Integrated Pocket Calculator” on page 80).
n
Detail magnification is now also possible in plan view (see
“Magnifying details” on page 426).
n
When program sections are copied, the copied block remains
highlighted after having been inserted (see “Marking, copying,
deleting and inserting program sections” on page 69).