HEIDENHAIN iTNC 530 (340 420) - Manual (Page 39)

HEIDENHAIN iTNC 530 11
1
.4 Stat
us Displa
ys
Positions and coordinates
Information on tools
Coordinate transformations
See “Coordinate Transformation Cycles” on page 338.
2
4
1
3
1 Position display
2 Type of position display, e.g. actual position
3 Tilt angle of the working plane
4 Angle of a basic rotation
3 2
5
1
4
6
1 n T: Tool number and name
n RT: Number and name of a replacement tool
2 Tool axis
3 Tool lengths and radii
4 Oversizes (delta values) from TOOL CALL (PGM) and the tool
table (TAB)
5 Tool life, maximum tool life (TIME 1) and maximum tool life for
TOOL CALL (TIME 2)
6 Display of the active tool and the (next) replacement tool
7 8
4
1
2
3
5 6
1 Name of main program
2 Name of the active datum table, active datum number (#),
comment from the active line of the active datum number (DOC)
from Cycle 7
3 Name of the active preset table, active preset number (#),
comment from the active line of the active preset number (DOC)
4 Active datum shift (Cycle 7)
5 Mirrored axes (Cycle 8)
6 Active rotation angle (Cycle 10)
7 Active scaling factor(s) (Cycles 11 / 26)
8 Scaling datum