HEIDENHAIN iTNC 530 (340 420) - Manual (Page 7)

HEIDENHAIN iTNC 530 III
New features of the NC software 340 420-xx
n Connecting the TNC to Windows networks via Ethernet (see
“Network settings specific to the device” on page 454)
n Definition of overlapping contours with contour formula (see “SL
Cycles with Contour Formula” on page 321)
n Stepwise magnification/reduction in the test graphic (see
“Rotating and magnifying/reducing the 3-D view” on page 425)
n The additional status display was expanded to display the active
datum table and the active datum number (see “Coordinate
transformations” on page 11).
n Find/Replace any text (see “The TNC search function” on page 70)
n
Changing the position of the current block on the screen (see
“Editing a program” on page 67)
n
New Q parameter functions: Check sign and Calculate modulo
value when entering formulas (see “Entering Formulas Directly” on
page 404)
n
Generating a file with version numbers (see “Code Numbers” on
page 445)
n Plunging feed rate for infeed for finishing new in Cycles 210 and 211
(see “SLOT (oblong hole) with reciprocating plunge-cut (Cycle
210),” page 281 and see “CIRCULAR SLOT (oblong hole) with
reciprocating plunge-cut (Cycle 211),” page 283)