HEIDENHAIN iTNC 530 (340 420) - Manual (Page 321)

HEIDENHAIN iTNC 530 293
8.5 Cy
cles f
o
r Mac
h
ining Hole P
a
tt
er
ns 7 CYCL DEF 220 POLAR PATTERN Define cycle for circular pattern 1, CYCL 200 is called automatically,
Q216=+30 ;CENTER IN 1ST AXIS Q200, Q203 and Q204 are effective as defined in Cycle 220.
Q217=+70 ;CENTER IN 2ND AXIS
Q244=50 ;PITCH CIRCLE DIA.
Q245=+0 ;STARTING ANGLE
Q246=+360 ;END ANGLE
Q247=+0 ;STEPPING ANGLE
Q241=10 ;NR. OF REPETITIONS
Q200=2 ;SAFETY CLEARANCE
Q203=+0 ;SURFACE COORDINATE
Q204=100 ;SECOND SET-UP CLEARANCE
Q301=1 ;TRAVERSE TO CLEARANCE HEIGHT
8 CYCL DEF 220 POLAR PATTERN Define cycle for circular pattern 2, CYCL 200 is called automatically,
Q216=+90 ;CENTER IN 1ST AXIS Q200, Q203 and Q204 are effective as defined in Cycle 220.
Q217=+25 ;CENTER IN 2ND AXIS
Q244=70 ;PITCH CIRCLE DIA.
Q245=+90 ;STARTING ANGLE
Q246=+360 ;END ANGLE
Q247=30 ;STEPPING ANGLE
Q241=5 ;NR. OF REPETITIONS
Q200=2 ;SET-UP CLEARANCE
Q203=+0 ;SURFACE COORDINATE
Q204=100 ;SECOND SET-UP CLEARANCE
Q301=1 ;TRAVERSE TO CLEARANCE HEIGHT
9 L Z+250 R0 FMAX M2 Retract in the tool axis, end program
10 END PGM PATTERN MM