HEIDENHAIN iTNC 530 (340 420) - Manual (Page 13)

HEIDENHAIN iTNC 530 IX
1.1 The iTNC 530 ..... 2
Programming: HEIDENHAIN conversational and ISO formats ..... 2
Compatibility ..... 2
1.2 Visual Display Unit and Keyboard ..... 3
Visual display unit ..... 3
Screen layout ..... 4
Keyboard ..... 5
1.3 Modes of Operation ..... 6
Manual Operation and Electronic Handwheel ..... 6
Positioning with Manual Data Input (MDI) ..... 6
Programming and editing ..... 7
Test Run ..... 7
Program Run, Full Sequence and Program Run, Single Block ..... 8
1.4 Status Displays ..... 9
“General” status display ..... 9
Additional status displays ..... 10
1.5 Accessories: HEIDENHAIN 3-D Touch Probes and Electronic Handwheels ..... 13
3-D touch probes ..... 13
HR electronic handwheels ..... 14
2.1 Switch-on, Switch-O ff ..... 16
Switch-on ..... 16
Switch-off ..... 17
2.2 Moving the Machine Axes ..... 18
Note ..... 18
To traverse with the machine axis direction buttons: ..... 18
Traversing with the HR 410 electronic handwheel ..... 19
Incremental jog positioning ..... 20
2.3 Spindle Speed S, Feed Rate F and Miscellaneous Functions M ..... 21
Function ..... 21
Entering values ..... 21
Changing the spindle speed and feed rate ..... 21
2.4 Datum Setting (Without a 3-D Touch Probe) ..... 22
Note ..... 22
Preparation ..... 22
Datum setting ..... 23
1 Introduction ..... 1
2 Manual Operation and Setup ..... 15