HEIDENHAIN iTNC 530 (340 420) - Manual (Page 517)

HEIDENHAIN iTNC 530 489
13.3 T
e
c
hnical Inf
o
rm
ation
Program Run graphics
Display modes
n
Graphic simulation of real-time machining in plan view / projection in 3 planes / 3-D
view
Machining time n Calculating the machining time in the Test Run mode of operation
n Display of the current machining time in the Program Run modes
Returning to the contour n Mid-program startup in any block in the program, returning the tool to the calculated
nominal position to continue machining
n Program interruption, contour departure and reapproach
Datum tables n Several datum tables
Pallet tables n Pallet tables (with as many entries as desired for the selection of pallets, NC programs
and datums) can be machined workpiece by workpiece or tool by tool
Touch probe cycles n Calibrating a touch probe
n
Compensation of workpiece misalignment, manual or automatic
n
Datum setting, manual or automatic
n Automatic workpiece measurement
n Cycles for automatic tool measurement
Specifications
Components
n
MC 422 main computer
n
CC 422 controller unit
n Keyboard
n TFT 10.4-inch or 15.1-inch flat-panel display with soft keys
Program memory
n
Hard disk with at least 2 GB for NC programs
Input resolution and display
step n To 0.1 µm for linear axes
n To 0.0001° for angular axes
Input range
n
Maximum 99 999.999 mm (3937 in.) or 99 999.999°
Interpolation n Line in 4 axes
o Line in 5 axes (subject to export permit) (software option 2)
n
Arc in 2 axes
m
Arc in 3 axes with tilted working plane (software option 1)
n Helix:
Combination of circular and linear motion
n Spline:
Execution of splines (3rd degree polynomials)
Block processing time
3-D straight line without radius
compensation
n
3.6 ms
o 0.5 ms (software option 2)
User functions