HEIDENHAIN iTNC 530 (340 420) - Manual (Page 482)

454 12 MOD Functions
12.5 Ether
n
et Int
e
rf
ace
Network settings specific to the device
U U U U Press the soft key DEFINE MOUNT to enter the network settings
for a specific device. You can define any number of network
settings, but you can manage only seven at one time.
Setting Meaning
MOUNTDEVICE
n
Connection via NFS:
Name of the directory that is to be logged on.
This is formed by the network address of the
server, a colon and the name of the directory to
be mounted. Input: four numerical values
separated by points. Ask your network
specialist for the values, e.g. 160.1.13.4.
Directory of the NFS server that you wish to
connect to the TNC. Be sure to differentiate
between small and capital letters when
entering the path.
n Connection to individual Windows computer:
Enter the network name and the share name of
the computer, e.g. //PC1791NT/C
MOUNTPOINT Name that the TNC shows in the file manager for
a connected device. Remember that the name
must end with a colon.
FILESYSTEM-
TYPE File system type.
nfs
: Network File System
smb : Windows network
OPTIONS for
FILESYSTEM-
TYPE=nfs Data without spaces, separated by commas, and
written in sequence. Switch between upper and
lower case letters.
rsize=:
Packet size in bytes for data reception.
Input range: 512 to 8192
wsize=:
Packet size in bytes for data
transmission. Input range: 512 to 8192
time0=:
Time, in tenths of a second, after which
the TNC repeats a Remote Procedure Call. Input
range: 0 to 100 000. If there is no entry, the
standard value 7 is used. Use higher values only
if the TNC must communicate with the server
through several routers. Ask your network
specialist for the proper value.
soft=:
Definition of whether the TNC should
repeat the Remote Procedure Call until the NFS
server answers.
“soft” entered: Do not repeat the Remote
Procedure Call.
“soft” not entered: Always repeat the Remote
Procedure Call.