HEIDENHAIN TNC 310 (286 140) - Manual (Page 8)

Contents
V HEIDENHAIN TNC 310
6 PROGRAMMING: PROGRAMMING CONTOURS.....55
6.1 Overview of Tool Movements.....56
6.2 Fundamentals of Path Functions.....57
6.3 Contour Approach and Departure.....60
Overview: Types of paths for contour approach and departure.....60
Important positions for approach and departure.....60
Approaching on a straight line with tangential connection: APPR LT.....62
Approaching on a straight line perpendicular to the first contour point: APPR LN.....62
Approaching on a circular arc with tangential connection: APPR CT.....63
Approaching on a circular arc with tangential connection from a straight line to the contour: APPR LCT.....64
Departing tangentially on a straight line: DEP LT.....65
Departing on a straight line perpendicular to the last contour point: DEP LN.....65
Departing tangentially on a circular arc: DEP CT.....66
Departing on a circular arc tangentially connecting the contour and a straight line: DEP LCT.....67
6.4 Path Contours — Cartesian Coordinates.....68
Overview of path functions.....68
Straight line L.....69
Inserting a chamfer CHF between two straight lines.....69
Circle center CC.....70
Circular path C around circle center CC.....71
Circular path CR with defined radius.....72
Circular path CT with tangential connection.....73
Corner Rounding RND.....74
Example: Linear movements and chamfers with Cartesian coordinates.....75
Example: Circular movements with Cartesian coordinates.....76
Example: Full circle with Cartesian coordinates.....77
6.5 Path Contours—Polar Coordinates.....78
Polar coordinate origin: Pole CC.....78
Straight line LP.....79
Circular path CP around pole CC.....79
Circular path CTP with tangential connection.....80
Helical interpolation.....81
Example: Linear movement with polar coordinates .....83
Example: Helix .....84