HEIDENHAIN TNC 310 (286 140) - Manual (Page 201)

189 HEIDENHAIN TNC 310
1
1
.1 Gr
aphics
To change the detail magnification:
The soft keys are listed in the table above.
ú Interrupt the graphic simulation, if necessary.
ú Select the workpiece surface with the corresponding
soft key (see table).
ú To reduce or magnify the blank form, press the minus
or plus soft key, respectively.
ú To select the isolated detail, press the TRANSFER
DETAIL soft key
ú Restart the test run or program run.
Repeating graphic simulation
A part program can be graphically simulated as often as desired,
either with the complete workpiece or with a detail of it.
Function Soft key
Restore workpiece blank to the detail
magnification in which it was last shown
Reset detail magnification so that the machined
workpiece or workpiece blank is displayed as it
was programmed with BLK FORM
The WINDOW BLK FORM soft key will return the blank
form to its original shape or size, even if a detail has
been isolated and not yet magnified with TRANSFER
DETAIL.