HEIDENHAIN TNC 310 (286 140) - Manual (Page 111)

99 HEIDENHAIN TNC 310
REAMING (Cycle 201)
1 The TNC positions the tool in the tool axis at rapid traverse FMAX
to the programmed set-up clearance above the workpiece
surface.
2 The tool reams to the entered depth at the programmed feed
rate F.
3 If programmed, the tool remains at the hole bottom for the
entered dwell time.
4 The tool then retracts to set-up clearance at the feed rate F, and
from there — if programmed — to the 2nd set-up clearance in
FMAX.
Before programming, note the following:
Program a positioning block for the starting point (hole
center) in the working plane with RADIUS
COMPENSATION R0.
The algebraic sign for the depth parameter determines
the working direction.
ú Set-up clearance Q200 (incremental value):
Distance between tool tip and workpiece surface.
ú Depth Q201 (incremental value): Distance between
workpiece surface and bottom of hole
ú Feed rate for plunging Q206: Traversing speed of
the tool during reaming in mm/min
ú Dwell time at depth Q211: Time in seconds that
the tool remains at the hole bottom
ú Retraction feed rate Q208: Traversing speed of the
tool in mm/min when retracting from the hole. If
you enter Q208 = 0, the tool retracts at the
reaming feed rate.
ú Workpiece surface coordinate Q203 (absolute
value): Coordinate of the workpiece surface
ú 2nd set-up clearance Q204 (incremental value):
Coordinate in the tool axis at which no collision
between tool and workpiece (clamping devices)
can occur.
X
Z
Q200
Q201
Q206
Q211
Q203
Q204
Q208
8.2 Dr
illing Cy
cles