Grass Valley SMS-6000 Series - Manual (Page 46)

2-1
2
Installation
Introduction
This section describes how to install your Series 6000. The system has been
designed with the aim of being quick and simple to install.
Unpacking
Remove the equipment carefully from the boxes and check against the
Packing List supplied with each unit. This shows what items have been
shipped against your order and includes all options. Any error should be
reported immediately. After you have unpacked the equipment, please
save all the packing material as this could be useful in the future if the unit
needs to be returned for maintenance.
Check each item supplied for transit damage. Any damage should be
reported in detail. You must state the serial number of the unit (to be found
on the rear, side or base of each unit).
Locate the power cords suitable for your country and verify that the
equipment has been set to the correct mains (line) voltage.
NOTE: Remote panels are mains powered and must also be checked.
Instructions are to be found later in this section on how to change the
voltage.