Grass Valley SMS-6000 Series - Manual (Page 27)

1-10
Section 1 — Introduction
Computer Ports
The computer port is used to connect to dumb terminals or to computers.
An IBM 80486, or higher, is recommended. At a minimum the users should
have the following:
■
IBM PC, PS/2 or 100% compatible
■
MS–Dos 3.3 or higher
■ 4MB RAM
■
1 MB hard disk required
■ RS232 Serial Port
■
MS or compatible mouse
NOTE: Run setup from DOS or there may not be sufficient memory to use the text
editor.
Serial Interface SMS–CSI
The Serial Interface can be used to enable a computer to be used with the
SMS-6000 Configuration Editor, or for remote control applications. It is an
option which is installed in the master frame.
Normally this option is installed at the factory prior to shipment. The
instructions below are for use if the option is supplied after shipment of the
main unit.
Installation
Remove the serial interface submodule from its packing. Check that its
pins are straight and undamaged. Set the jumpers on the Serial Interface
module. Follow the steps listed below.
Installation in Matrix Frames
1. Unplug the power.
2. Unscrew the front panel retaining screws. The blank panel can then be
removed. If a local control panel is mounted on the frame, disconnect
the ribbon cables from the front of the matrix module. Release the
retaining latches to withdraw the ribbon cable plugs and remove the
panel.
3. Use the release catches at the sides of the matrix module to release the
locks which hold the module in place. Then pull the catches outwards
to eject the module from its edge connectors.