Grass Valley SMS-6000 Series - Manual (Page 28)

1-11
Serial Interface SMS–CSI
4. Remove the module and carefully place it on an anti-static surface.
5. Position the serial interface submodule over the matrix module using
the hole as a guide.
CAUTION
If the module is positioned incorrectly, damage may result to both assemblies.
6. Line the pins over the sockets and push the submodule down gently
and evenly so that all pins enter the sockets at the same time. Push
firmly to completely seat the submodule.
7. Reinstall the matrix module in the frame. Press the module in firmly to
seat it in its connector.
8. Reconnect the power.
Setup
RS422 or RS232 Mode
This is the hardware standard supported by the Computer Port. Set it to
suit the computer or terminal to be used by moving jumper links on the
Serial Interface module. Position the module so that the large chip is top
left.
Depending on which Serial Interface module you have the jumper settings
are as follows:
Set jumpers LK1-5 toward the front of the frame for RS422
toward the rear of the frame for RS232
or
Set the single jumper to the left for RS232 or to the right for RS422 as
indicated on the module
Figure 1-2. Serial Interface Jumper Setiings
• • • • •
• • • • •
• • • • •
RS422 RS232
• • •
232 422
162106-00
162180-00