Grass Valley SMS-6000 Series - Manual (Page 101)

4-9
SMS-CXY Control Panel
Clear
If an error is made during entry of names on the keypad, press the CLEAR
button to clear the display.
Destinations
To enter the destination select mode press the left-hand button (DEST)
under the display; the LED in this button lights. Then select a new
destination using the keypad. The name is built up in the lower preset
section of the display. When you are satisfied with the new destination, exit
the destination select mode by pressing the (DEST) button again, or by
pressing the TAKE button. The new destination is transferred to the in use
upper section of the display, alongside its current source selections.
Sources
When you have left the destination select mode you can select the source.
The source name is built up in the display in the same way as for
destinations.
Take Button
When the desired source is selected into the preset section of the display,
press the TAKE button to make a cut to the new source.
Breakaways
Four buttons are provided to enable breakaway selections of signal levels,
such as video, audio 1, audio 2, and time code. These buttons can be labeled
to suit each application. The system setup determines which buttons are
active and which breakaways are allowed.
Lock
This button allows you to protect a source/destination selection. When
you press the LOCK button it can lock just the current destination or it can
lock all destinations. The choice of lock modes is set in the software
configuration.
1. Press the button once to lock the panel. The green display shows that
the panel is locked.
2. Press the button again to unlock the panel.