Grass Valley SMS-6000 Series - Manual (Page 34)

1-17
Remote Control Panels
Remote Control Panels
Refer to Section 4: Control Panels for details of the control panels and their
operation. The following points apply to most panels.
General Points
Remote panels are used to indicate current crosspoint connections and to
make new selections at various locations to suit the user. Most panels are
connected to the frame via the Quick-Link coaxial link. The identity of each
panel is determined by the unique setting of a rotary hex switch in each
panel.
Each panel is set up to operate in a particular way by the system
configuration located in the master frame of the system. This determines, for
instance, which destinations can be controlled from each panel. The rotary
hex switch mentioned above serves to route the correct setup to each panel.
Panels are powered from a local 115V/230V mains supply.