Grass Valley SMS-6000 Series - Manual (Page 126)

A-10
Appendix A — Remote Control Protocol
Examples
Note that (cr) ASCII carriage return (code 0D hex). Refer to Table A-10.
Table A-10. Examples of Various Commands/Replies
From Computer From Router Description
(cr).P(cr) power on or reset
.SV003,001(cr) .UV003,001(cr) set destination-3 to source-1 on level-1
.SV3,1(cr) .UV003,001(cr) set destination-3 to source-1 on level-1
.SVAB02,001(cr) .UVAB002,001(cr) set destination-2 to source-1 on levels-
1,2,3
.SZ1,3(cr) .E(cr) level Z not allowed
.SB45,12 .E(cr) destination too large
.IV1(cr) .AV001,001(cr) get status of level-1 destination-1
.IA3(cr) .AA003,002(cr) get status of level-2, destination-3
.IVABC9(cr) .E(cr) only one level can be interrogated
.LV5,-(cr) .AV005,002V006,009V007,010V
008,031V009,001V010,001V011
,017V012,003(cr) get status of level-1 destination-5 to
destination-12
.LB1,1(cr) .AB001,001B007,001B(cr) only destination-1 and destination-7 using
source-1
.UV007,003(cr) system change by a control panel or
another computer interface
.#01(cr) .A(cr) check to see if router connected
.?0C40(cr) .A0C40,02,34,7F,2D,20,20,20,0D
(cr) read of system setup data
.!328E,01,02,56,7F(cr) .A328E,01,02,56,7F (cr) write of system setup data