Grass Valley K2 Dyno S v.3.0 - Manual (Page 9)

Safety Summaries
K2 Dyno S Replay Controller 9 Installation & Service Manual
4 December 2012
Use correct power source — Do not operate this product from a power source that applies
more than the voltage specified for the product.
Use correct voltage setting — If this product lacks auto-ranging power supplies, before
applying power ensure that the each power supply is set to match the power source.
Provide proper ventilation — To prevent product overheating, provide equipment
ventilation in accordance with installation instructions.
Use anti-static procedures — Static sensitive components are present which may be
damaged by electrostatic discharge. Use anti-static procedures, equipment and surfaces
during servicing.
Do not operate with suspected equipment failure — If you suspect product damage or
equipment failure, have the equipment inspected by qualified service personnel.
Ensure mains disconnect — If mains switch is not provided, the power cord(s) of this
equipment provide the means of disconnection. The socket outlet must be installed near the
equipment and must be easily accessible. Verify that all mains power is disconnected
before installing or removing power supplies and/or options.
Route cable properly — Route power cords and other cables so that they ar not likely to be
damaged. Properly support heavy cable bundles to avoid connector damage.
Use correct power supply cords — Power cords for this equipment, if provided, meet all
North American electrical codes. Operation of this equipment at voltages exceeding 130
VAC requires power supply cords which comply with NEMA configurations. International
power cords, if provided, have the approval of the country of use.
Use correct replacement battery — This product may contain batteries. To reduce the risk
of explosion, check polarity and replace only with the same or equivalent type
recommended by manufacturer. Dispose of used batteries according to the manufacturer’s
instructions.
Troubleshoot only to board level — Circuit boards in this product are densely populated
with surface mount technology (SMT) components and application specific integrated
circuits (ASICS). As a result, circuit board repair at the component level is very difficult in
the field, if not impossible. For warranty compliance, do not troubleshoot systems beyond
the board level.