Grass Valley K2 Dyno S v.3.0 - Manual (Page 44)

Chapter 3 Service procedures Replacing a K2 Dyno S Replay Controller
K2 Dyno S Replay Controller 44 Installation & Service Manual
4 December 2012
2. When restart completes, you are prompted to rename the computer. Enter a name for
the K2 Dyno Replay Controller and click Next .
The name assigned by default by the factory is the serial number of the unit.
3. Set NIC names as follows:
- Set rear panel Ethernet port 1 to GB1
- Set rear panel Ethernet port 2 to GB2
4. Install Dyno Client software as instructed in release notes.
When installing software, if prompted to enter the serial number, leave the serial
number field blank. Do not enter the serial number.
Replacing a K2 Dyno S Replay Controller
To correct some system faults Grass Valley Support sends you a replacement K2 Dyno S
Replay Controller. Contact Grass Valley Support if you think you need a replacement K2
Dyno S Replay Controller.