Grass Valley K2 Dyno S v.3.0 - Manual (Page 18)

Certifications and compliances
K2 Dyno S Replay Controller 18 Installation & Service Manual
4 December 2012
482 S1. People performing such an act are required by law to recertify and reidentify this
product in accordance with provisions of 21CFR subchapter J for distribution within the
U.S.A., and in accordance with CENELEC HD 482 S1 for distribution within countries
using the IEC 825 standard.
Laser safety
Laser safety in the United States is regulated by the Center for Devices and Radiological
Health (CDRH). The laser safety regulations are published in the “Laser Product
Performance Standard,” Code of Federal Regulation (CFR), Title 21, Subchapter J.
The International Electrotechnical Commission (IEC) Standard 825, “Radiation of Laser
Products, Equipment Classification, Requirements and User’s Guide,” governs laser
products outside the United States. Europe and member nations of the European Free Trade
Association fall under the jurisdiction of the Comité Européen de Normalization
Electrotechnique (CENELEC).
Safety certification
This product has been evaluated and meets the following Safety Certification Standards:
Standard Designed/tested for compliance with:
ANSI/UL 60950-1 Safety of Information Technology Equipment, including
Electrical Business Equipment (Second edition 2007).
IEC 60950-1 with CB
cert. Safety of Information Technology Equipment, including
Electrical Business Equipment (Second edition, 2005).
CAN/CSA C22.2 No.
60950-1 Safety of Information Technology Equipment, including
Electrical Business Equipment (Second edition 2007).
BS EN 60950-1 Safety of Information Technology Equipment, including
Electrical Business Equipment 2006.