Grass Valley K2 Dyno S v.3.0 - Manual (Page 29)

Chapter 2 Dyno S Controller Installation Cable K2 Summit 3G Client
K2 Dyno S Replay Controller 29 Installation & Service Manual
4 December 2012
Cable K2 Summit 3G Client
For a K2 Summit Client system, a typical basic installation can use the cable connections
as illustrated.
NOTE: For Ethernet control, use the lower left port (as viewed from the rear).
If a ChannelFlex option is present, additional cabling options are available.
For complete cabling instructions, refer to the K2 System Guide.
Cable K2 Solo
A K2 Solo system is essentially half of a K2 Summit, with two bidirectional channels. A
typical installation for use with a Dyno S Controller are illustrated.
If a ChannelFlex option is present, additional cabling options are available.
For complete cabling instructions, refer to the K2 System Guide.
NOTE: For Ethernet control, use the lower left port (as viewed from the rear).
Channels (C1, C2, C3, C4) are bi-directional
Use C1 as record
channel. Connect
C1 SDI in 1
Use C2 as record
channel. Connect
C2 SDI in 1
Use C3 as play
channel. Connect
C3 SDI out 1
Use C4 as play
channel. Connect
C4 SDI out 1
Power
cord
Power
cord
Reference
Loop
AES audio
(1 for each
channel)
Keyboard
and mouse
(2 USB)
VGA
monitor
Ethernet control
connection
Optional:
Ethernet media
(FTP) connection
C1 C2
USB/1394
100-240 V-
4-2A,
60-50Hz
100BT/1000BT
GPI VGA REF. LOOP THROUGH
SDI IN1 SDI OUT1 SDI OUT2 LTC I/O
AES AUDIO RS422
SDI OUT1 SDI OUT2
AES AUDIO RS422
LTC I/O SDI IN2 SDI IN3 SDI IN1 SDI IN2 SDI IN3
Power
cord Keyboard
and mouse VGA
monitor Ethernet
control
connection
Optional:
Ethernet
media (FTP)
connection
Channels (C1, C2) are bi-directional
Use C1 as record
channel. Connect
SDI in Use C2 as
play channel.
Connect SDI out
AES
audio