Grass Valley K2 Dyno S v.3.0 - Manual (Page 17)

K2 Dyno S Replay Controller 17 Installation & Service Manual
4 December 2012
Certifications and compliances
Canadian certified power cords
Canadian approval includes the products and power cords appropriate for use in the North
America power network. All other power cords supplied are approved for the country of
use.
FCC emission control
This equipment has been tested and found to comply with the limits for a Class A digital
device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide
reasonable protection against harmful interference when the equipment is operated in a
commercial environment. This equipment generates, uses, and can radiate radio frequency
energy and, if not installed and used in accordance with the instruction manual, may cause
harmful interference to radio communications. Operation of this equipment in a residential
area is likely to cause harmful interference in which case the user will be required to correct
the interference at his own expense. Changes or modifications not expressly approved by
Grass Valley can affect emission compliance and could void the user’s authority to operate
this equipment.
Canadian EMC Notice of Compliance
This digital apparatus does not exceed the Class A limits for radio noise emissions from
digital apparatus set out in the Radio Interference Regulations of the Canadian Department
of Communications.
Le présent appareil numérique n’émet pas de bruits radioélectriques dépassant les limites
applicables aux appareils numériques de la classe A préscrites dans le Règlement sur le
brouillage radioélectrique édicté par le ministère des Communications du Canada.
EN55103 1/2 Class A warning
This product has been evaluated for Electromagnetic Compatibility under the EN 55103-1/
2 standards for Emissions and Immunity and meets the requirements for E4 environment.
This product complies with Class A (E4 environment). In a domestic environment this
product may cause radio interference in which case the user may be required to take
adequate measures.
FCC emission limits
This device complies with Part 15 of the FCC Rules. Operation is subject to the following
two conditions: (1) This device may not cause harmful interference, and (2) this device
must accept any interference received, including interference that may cause undesirable
operation.
Laser compliance
Laser safety requirements
This product may contain a Class 1 certified laser device. Operating this product outside
specifications or altering its original design may result in hazardous radiation exposure, and
may be considered an act of modifying or new manufacturing of a laser product under U.S.
regulations contained in 21CFR Chapter 1, subchapter J or CENELEC regulations in HD