Grass Valley K2 Dyno S v.3.0 - Manual (Page 43)

Chapter 3 Service procedures Restoring from a generic recovery disk image
K2 Dyno S Replay Controller 43 Installation & Service Manual
4 December 2012
• Expand the node for Removable Drive (A:) . This is the Recovery Flash Drive. Select
the image file. The file for the image supplied by the Grass Valley factory is named
with the serial number of the K2 Dyno S Replay Controller.
• Navigate to the location of the image file from which you are restoring.
An image file has a .tib file name extension.
7. Click Next :
The Restoration Type Selection page opens.
8. Select Restore disks or partitions and then click Next .
The Partition or Disk to Restore page opens.
9. Select FAT32 (C:) and then click Next .
The Restored Partition Location page opens.
10.Select FAT32 (C:) and then click Next .
The Restored Partition Type page opens.
11.Leave the selection at Active and then click Next .
The Restored Partition File System page opens.
12.Select FAT32 and then click Next .
The Restored Partition Size page opens.
13.Leave settings at their defaults. The size reported in the upper pane is the size
detected of the actual C: partition. This should be the same as that reported in the
Partition size field in the middle of the page. Free space before and Free space after
should both be reported at 0 bytes. Click
Next .
The Next Selection page opens.
14.Select No, I do not and then click Next .
The Restoration Options page opens.
15.Do not change any settings on this page. Click Next .
16.Click Proceed .
The Operation Progress page opens and displays progress.
17.When a “The data was successfully restored” message appears, click OK .
18.Click Operations | Exit to exit the Acronis True Image program.
The K2 Dyno S Replay Controller restarts automatically.
19.Remove the Recovery Flash Drive while the K2 Dyno S Replay Controller is shutting
down.
Restoring from a generic recovery disk image
Use this procedure to restore from a generic baseline image that does not apply to any
specific system. Use this procedure only as directed by release notes or by Grass Valley
support.
1. Perform step 1 on page 42 through step 19 above to restore the K2 Dyno S Replay
Controller to a generic image.