Grass Valley K2 Dyno S v.3.0 - Manual (Page 37)

Chapter 3 Service procedures Launch Dyno application from maintenance mode
K2 Dyno S Replay Controller 37 Installation & Service Manual
4 December 2012
4. Touch Restart to go to the Windows OS desktop.
Launch Dyno application from maintenance mode
When in maintenance mode, you can relaunch the Dyno application by double touching the
Dyno Replay Controller icon on the desktop.
Hardware diagnostics
The K2 Dyno S Replay Controller has a built-in hardware diagnostics tool available for
testing hardware.
To run the hardware diagnostics, you need to start up the K2 Dyno S Replay Controller in
Maintenance mode. With the K2 Dyno S Replay Controller diagnostics, you can check if
the hardware is operating normally as to whether:
• the buttons are illuminated in corresponding colors
• the T-Bar position information is correct
• the hardware responds to the JOG operations properly
• the touch panel detects correct positions
1. While in a regular Dyno software session, touch Config | Exit and select the option for
Maintenance mode.
The Windows desktop displays.