Grass Valley K2 Dyno S v.3.0 - Manual (Page 51)

Chapter 4 Dyno S Controller FRUs Open chassis
K2 Dyno S Replay Controller 51 Installation & Service Manual
4 December 2012
2. Open chassis so the top is upside-down on the padded work surface (see “Open
chassis” on page 51 ).
WARNING: To avoid serious injury from high currents, turn off the K2 Dyno S
Replay Controller and disconnect AC power before opening the top cover
or removing any internal parts.
3. Remove cable from T-bar assembly.
4. Remove 4 locking hex nuts, using a 1/4 in. wrench, and lift out the T-bar assembly.
Open chassis
The K2 Dyno S Replay Controller chassis can be opened to access internal hardware.
WARNING: To avoid serious injury from high currents, turn off the K2 Dyno S
Replay Controller and disconnect AC power before opening the top cover
or removing any internal parts.
1. Turn off the unit and unplug the unit’s AC power cord.
2. Place padding or a cloth onto the work surface to protect the top surface of the unit.
8702_08