Grass Valley K2 Dyno S v.3.0 - Manual (Page 45)

K2 Dyno S Replay Controller 45 Installation & Service Manual
4 December 2012
Chapter
4
Dyno S Controller FRUs
Field Replaceable Units (FRUs) are modular hardware components that can be serviced
without disturbing other components in the system. The following topics show how to
disassemble K2 Dyno S Replay Controller FRUs. Unless otherwise documented,
re-assembly is the reverse.
WARNING: The K2 Dyno S Replay Controller power standby switch does not turn off
power to the system. To turn power off the system must be disconnected
from the power source.
WARNING: To avoid serious injury from high currents, turn off the K2 Dyno S
Replay Controller and disconnect AC power before opening the top cover
or removing any internal parts.
CAUTION: This system contains board-level components that must be protected from
static discharge and physical shock. Wear a wrist strap grounded through
one of the system's ESD Ground jacks when handling system components.
NOTE: Only Grass Valley components are supported. Do not attempt to use
components procured from a different source.
NOTE: Do not discard any hardware unless specifically instructed to do so.