4 call, 5 return channels, 6 incoming channels – Grass Valley DMC 1000 v.12.4 User Manual
Page 91: Call, Return channels, Incoming channels
DMC 1000 Digital Media Camcorder User’s Guide (v4.0)
91
Chapter 6 - Audio setup
6.7.4 Call
Either user button can be assigned to the intercom Call function. When the user button is
pressed, a signal is sent to a connected OCP 400 control panel, calling for attention. The CALL
button on the OCP 400 lights green.
The ND/RE indicator in the viewfinder also lights when a call signal is sent or received.
☞
Note
☞
Note
This function is only available when the SYSTEM
>
HARDWARE
>
NETWORK
>
REMOTE
REC
item
is turned off.
6.7.5 Return channels
The return intercom channels (Engineering and Production return) can be output to the
embedded SDI audio channels, depending on your transmission configuration:
1.
Go to the AUDIO
>
OUTPUTS
>
SDI
OUT
menu.
2.
Tap the button of the SDI channel you want to use for the Engineering return channel,
3.
Select Eng-Ret,
4.
Tap the button of the SDI channel you want to use for the Production return channel,
5.
Select Prod-Ret.
6.7.6 Incoming channels
Set up the built-in audio mixer to combine the incoming intercom channels to your personal
preference:
1.
Go to the AUDIO
>
SYSTEM
>
MIXER
menu.
2.
Tap each SOURCE buttons and choose the following settings:
–
For SOURCE1, select Eng (incoming Engineering intercom channel),
–
For SOURCE2, select Prod (incoming Production intercom channel),
–
For SOURCE3, select Program (incoming Program intercom channel),