Grass Valley DMC 1000 v.12.4 - Manual (Page 84)

84 DMC 1000 Digital Media Camcorder User’s Guide (v4.0)
Chapter 6 - Audio setup
6.2.6 Gain settings
Set the input gain level in the AUDIO > INPUTS menu for:
• the front microphone inputs,
• the rear microphone inputs,
• the rear line-level inputs, and
• the optional wireless audio input.
6.3 Recording audio
6.3.1 Select source
To select the source for each of the four recording channels:
1. Go to the AUDIO > CHANNELS menu.
2. Tap one of the SOURCE CH buttons numbered 1 to 4.
3. Tap the arrows in the pop-up box to select a source for that channel.
The possible sources are:
• Rear1 - analog audio 1 input,
• Rear2 - analog audio 2 input,
• Wrx1 and Wrx2 - wireless audio channels (optional),
• Front1 - front microphone or stereo front microphone channel 1 (optional),
• Front2 - stereo front microphone channel 2 (optional)
• MicRear - rear mini-jack headset microphone,
• AES1 - digital audio input channel 1 via BNC connector,
• AES2 - digital audio input channel 2 via BNC connector,
• SDI In1..8 - embedded digital audio input channels from the SDI input,
• Sidetone - sidetone (intercom loopback) channel (when in systemized operation),
• Program - intercom Program channel (when in systemized operation),
• Eng - intercom Engineering channel (when in systemized operation),
• Prod - intercom Production channel (when in systemized operation), or
• Mute.
Four channels are always recorded. When a recording channel is not used, set the recording
source for that channel to Mute.