Grass Valley DD10 part 1 - Manual (Page 71)

2.10 Wipe Panel Diamond digital DD10
65
Via an RS 422 remote interface, the mixer can control some functions of defined
DVE devices.
These functions are:
D
Effect selection
D
Positioning within the effect
D
Tape motion commands “TMC” (PLAY, STOP, REVERSE, REWIND, FFWD)
DVE Effect
selection
Effect
position
TMC Protocol name Note
ABEKAS A53D yes yes yes DVE A53D Only Port1
connector RS-232
ABEKAS A57 yes yes yes DVE A53D Only Port1
connector RS-232
AMPEX ADO yes yes – DVE ADO
GVG DPM-700 yes yes yes DVE DPM
QUESTECH
CHARISMA
yes yes – DVE CHARIS Special cable
required
PINNACLE PRIZM yes yes – DVE PRIZM
Flip Flop determines the wipe direction. In the activated state, the wipe direction
is changed every time the lever is moved to a limit or the transition is completed.
Rev changes the preset wipe direction.
Pos activates the trackball on the Positioner panel. The trackball enables the user
to position the center of the selected pattern within the visible picture section.
Note: Please note that some wipe patterns (e.g. matrix wipe patterns) cannot
be positioned.
Extend Pos activates the trackball on the Positioner panel. The trackball enables
the user to position the center of the selected pattern at any place, even outside
the the visible picture section.
Note: Please note that in this mode, the wipe transition may reach its limit be-
fore the wipe pattern fully crosses the screen.
DVE effects
Wipe direction
Pattern
positioning