Grass Valley DD10 part 1 - Manual (Page 109)

2.14 Setup Diamond digital DD10
103
K E Y M E M O R Y : O N
Press Edit to enable and disable the key memory function. When this
function is enabled, the adjusted parameters of the previous key
source are stored whenever a new key source is selected. When the
previous key source is selected again, the parameters are again
available.
L O O K A H E A D P V W : >
In this sub-loop, the preview facility for the individual switcher levels
can be selected in three modes:
OFF PVW output =
ME output
ON PVW output = LOOK AHEAD PVW
DD20 / DD30 only:
oAIR If ME On–Air:
PVW output = LOOK AHEAD PVW
otherwise PVW output = ME output
A U X C O U P L E D : >
In the sub-loop, the available Aux output banks AUX 1... 3 can be
coupled with the internal switcher signals:
Coupling with itself is not possible.
K E Y C O U P L E D : >
In the sub-loop, key and fill sources from different inputs can be
coupled permanently.
The fill sources (e. g. F:IN01) can be selected successively with the
Bank key.
The desired key source (e. g. K:IN01) can then be selected with the
Edit key.
P O R T P :
With the Edit key you can select a protocol for the port interface at the
control panel:
-- (no protocol)
For details on the interfaces please refer to the installation manual.
E B O X P O R T P R O T : >
In the sub-loop, a protocol can be selected for each of the available
port interfaces PORT1, PORT2, and PORT3 of the E–box:
-- (no protocol)
For details on the interfaces please refer to the installation manual.
The list is updated continuously.