Grass Valley DD10 part 1 - Manual (Page 108)

2.14 Setup Diamond digital DD10
102
The Edit button can be used to switch over between ANY, FIELD1 and
FIELD2.
The setting concerns the switching of the crosspoints on all busses
(without Ext Anz), the start of auto transitions, switching with Cut and
the recalling of snapshots and timelines.
In position ANY switching occurs at the beginning of the next frame.
In position FIELD1/2 switching or starting occurs before the corre-
sponding field.
The Edit button can be used to switch over between ON and OFF.
In OFF position the V-gap is replaced by BLACK.
In ON position the information contained in the V-gap (VITS, videotext
etc.) are kept.
B G/P S T G E R M: O N
Edit permits switching over between ON and OFF.
If ON, the Program and Preset key banks are reversed, i. e. Program
is on the lower bank and Preset is on the upper bank.
Changing of AUTO- and CUT-key in the transition-panels.
B L A C K B T N : . . .
Press Edit to switch the BLACK picture source optionally to the right-
hand or the left-hand side of the key bank. The left or right position is
indicated in the display with a bar symbol.
M O U S E G A I N : 5 0 %
The mouse gain can be adjusted between 12 and 100 % with the ****
control in the Wipe panel.
T – B A L L G A I N : 5 0 %
The trackball gain can be adjusted between 12 and 100 % with the ****
control in the Wipe panel.
L O W – L I G H T : 3 0 %
The low light of all key lamps can be adjusted between 0 and 100 %
with the **** control in the Wipe panel.
B E E P: O N
Edit enables switching between the states ON and OFF.
If ON, a beep sound in the control panel indicates that in the adjust-
ment of an analog value the final position has been reached.
C O L O R L I M I T: O N
The level limitation for the internal matte signals will be switched ON
or OFF by pressing EDIT.
C O L . L I M I T E R : 1 3 0 %
The level limitation for the internal matte signals can be adjusted
between 100 and 130 % with the **** control in the Wipe panel.
A U T O P V W : O N
Press Edit to enable or disable the Auto PVW mode. When Auto
PVW is enabled, the key PVW, mask PVW or Chroma Key cursor sig-
nal is switched on the PVW bus.
F I E L D D O M I N : A N Y
V E R T T R A N S P : O N
C U T R I G H T: ON