Grass Valley DD10 part 1 - Manual (Page 20)

2.3 DVE Panel Diamond digital DD10
14
ÁÁÁÁÁÁÁÁ
ÁÁÁÁÁÁÁÁ
Á ÁÁÁÁÁÁÁ
Á ÁÁÁÁÁÁÁ
Á ÁÁÁÁÁÁÁ
ÁÁÁÁÁÁÁÁ
Mode 2
FX Loop without
fader
ÁÁÁÁÁÁÁÁÁÁÁÁÁÁÁÁÁÁÁÁÁÁÁÁÁ
ÁÁÁÁÁÁÁÁÁÁÁÁÁÁÁÁÁÁÁÁÁÁÁÁ Á
Á ÁÁÁÁÁÁÁÁÁÁÁÁÁÁÁÁÁÁÁÁÁÁÁ Á
Á ÁÁÁÁÁÁÁÁÁÁÁÁÁÁÁÁÁÁÁÁÁÁÁ Á
Á ÁÁÁÁÁÁÁÁÁÁÁÁÁÁÁÁÁÁÁÁÁÁÁ Á
ÁÁÁÁÁÁÁÁÁÁÁÁÁÁÁÁÁÁÁÁÁÁÁÁÁ
Select the DVE key on the Aux bus delegation bank.
Disable DVE transition in the Transition panel (if enabled).
Select the picture component to be switched to the DVE (Key 1, Key 2).
Enable Loop, i.e. switch DVE into the video path.
The DVE digipot in the Wipe panel permits running the DVE effect. As it is difficult
to achieve a continuous sequence with the digipot, this operation can only be
recommended for a static DVE positioning. A uniform movement can, however, be
realized with an EXTRA timeline. The picture component manipulated with the
DVE can be faded with Wipe or Mix in the Transition panel.
Note: Function Loop ON DVE in video path for the picture component
Function Loop OFF DVE not in video path for the picture component
ÁÁÁÁÁÁÁÁ
ÁÁÁÁÁÁÁÁ
Á ÁÁÁÁÁÁÁ
Á ÁÁÁÁÁÁÁ
Á ÁÁÁÁÁÁÁ
Á ÁÁÁÁÁÁÁ
ÁÁÁÁÁÁÁÁ
Mode 3
DVE effects
without FX Loop ÁÁÁÁÁÁÁÁÁÁÁÁÁÁÁÁÁÁÁÁÁÁÁÁÁ
ÁÁÁÁÁÁÁÁÁÁÁÁÁÁÁÁÁÁÁÁÁÁÁÁ Á
Á ÁÁÁÁÁÁÁÁÁÁÁÁÁÁÁÁÁÁÁÁÁÁÁ Á
Á ÁÁÁÁÁÁÁÁÁÁÁÁÁÁÁÁÁÁÁÁÁÁÁ Á
Á ÁÁÁÁÁÁÁÁÁÁÁÁÁÁÁÁÁÁÁÁÁÁÁ Á
Á ÁÁÁÁÁÁÁÁÁÁÁÁÁÁÁÁÁÁÁÁÁÁÁ Á
ÁÁÁÁÁÁÁÁÁÁÁÁÁÁÁÁÁÁÁÁÁÁÁÁÁ
Select the DVE key on the Aux bus delegation bank.
Disable Loop.
Disable DVE transition in the Transition panel (if enabled).
In this mode, the following signals can be switched to the DVE:
•
all signals of the Aux bus; if a coupled key signal exists, this is sent to the DVE
as key signal.
•
video signals and – if existing – the pertaining key signal from the respective
switching level.
If only a video signal and no key signal exists, 100 % white is sent to the DVE as
key signal.
If the DVE delegation key is held down, any signal may be selected as key signal.