Grass Valley DD10 part 1 - Manual (Page 151)

3.5 Install menu Diamond digital DD10
145
On a DD20 or DD30 panel (where the LEDs and LED driver below the BTS logo
on the upstanding part are equipped!) it is now possible to select whether the BTS
logo illumination is OFF, ON or ON/OFF depending on the ON-AIR status of the
mixer.
Prepared panels:
DD20:panel serial number 149 and higher
DD30:panel serial number 140 and higher
KEYCLICK enables a short acoustical “Click” when a button is pushed.
At end of transition with TRANS PREVIEW on, the PGM and PST Bus do not longer
switch.
Operation of TRANS PVW can be modified. New setting TR-PVW
“Mode 1” = compatible operation.
TRANS PVW stays on and shows in endposition the final
image on the PVW output.
“Mode 2” = TRANS PVW goes automatically to the begin of the transition
when reaching the endposition
“Mode 3” = “One shot mode”.
TRANS PVW switches automatically off, when T-Bar goes to
either endposition.
Note: Also when returning to the begin TRANS PVW is
switched off.
Does not apply with LIMIT ON.
Note: Mode 2 and 3 behave as described when using the T–Bar for
controlling the transition. AUTO transition behaves as before
equivalent to Mode 1.
Press the associated function key to return to the higher order INSTALL menu.
P ress the respective function key to exchange the position of the AUTO and CUT
keys in the transition control panel. This function may be selected in the SETUP
of the switcher.
ON
LOGO
KEY
CLICK
Mode 1
TR-PVW
EXIT
CUT
RIGHT